Concrete Sealer Colour Kit Concrete Grey – Gloss 21 litres

or 4 fortnightly payments of $62.25 with Afterpay More info

$260.00 $249.00



Sealer Colour Kit Concrete Grey – Gloss 21 litres

Concrete Sealer is a new generation single component water based acrylic cross linking emulsion designed to protect and enhance concrete surfaces whilst providing many advantages over conventional sealers. It can be used over sound solvent based acrylic coatings which until now had to be totally stripped from the surface prior to application of a water based coating.


Residential driveways, patios, warehouses and light industrial building will benefit from applying concrete sealer

Concrete Sealer is excellent for interior application with no solvent fumes and does not have the flammable hazards of conventional solvent based products.

By applying 2 coats of Sealer, a colour enhancement not usually seen with water based sealers gives an attractive lift especially to coloured concrete surfaces.

* Excellent for Interior and Exterior use
* Water based, easy to use

* Low VOC
* Can be sprayed, brushed or applied by roller
* Quick drying
* Non Blushing
* Fast water resistance * within 2 hours
* Enhances/darkens surfaces
* Can be applied to damp surfaces
* Can be applied wet on wet
* Hard wearing surface resistant to abrasion
* Hot tyre resistant
* Chemical resistant * oils, greases, alkali
* Resists discoloration from dirt and spills
* UV resistant * non yellowing
* Provides a dust free surface

* 8-10m2 per litre, this is variable on application and porosity of the surface.

We recommend applying 2 coats of Concrete Sealer for optimum effect, but the
application must not be too thick as excessive build up may cause the coating to appear
milky when subjected to ponding. This effect will disappear when the coating dries
Apply to dry, dust free concrete surfaces only, caution on new concrete,
best to allow 5-7 days curing prior to sealing
* Surface can be damp but not wet
* Two coats recommended for optimum effect
* Can be applied wet on wet
* Apply with low pressure sprayer or good quality roller
* Dry Time – 40-60 minutes dependant on weather conditions
* Allow 24-48 hours to cure
* Do not apply when surface temperatures are below 10ºC
* Do not apply if rain is imminent
* Fast water resistance – within 2 hours
* Enhances colour
* Hot Tyre resistant
* Hard wearing and chemical resistant – oils, grease, alkali
* Allow full cure of Sealer before performing any cutting 5-7 days minimum
Clean up equipment with water immediately after use.

Call Now ButtonCall Us